This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
vaio_vgn-a497xp_disc_change [2007/06/01 16:53] – Draft of first half jim | vaio_vgn-a497xp_disc_change [2007/06/01 17:12] (current) – Add thanks jim | ||
---|---|---|---|
Line 38: | Line 38: | ||
Remove the keyboard and place it out of the way. | Remove the keyboard and place it out of the way. | ||
+ | |||
+ | ===== Remove base top cover ===== | ||
Next remove the two screws holding the top cover of the laptop base. The screwdrivers show where they are. | Next remove the two screws holding the top cover of the laptop base. The screwdrivers show where they are. | ||
{{baseplate-screws.jpg|Top cover screws}} | {{baseplate-screws.jpg|Top cover screws}} | ||
+ | |||
+ | Now very carefully ease the two small ribbon cables on the top cover out of their connectors. The screwdrivers show the location of the connectors. | ||
+ | |||
+ | {{top-cover-ribbons.jpg|Top cover ribbon cables}} | ||
+ | |||
+ | Now you can ease the top cover off. It is clicked in place along the screen edge. I just lifted it gently from the front, wiggled and persuaded until it came out. | ||
+ | |||
+ | ===== Remove the hard drive assembly ===== | ||
+ | |||
+ | The hard drive assembly is at the bottom left. Undo the six screws holding it in. | ||
+ | |||
+ | {{disc-assembly.jpg|Disc assembly}} | ||
+ | |||
+ | Fold the board covering the drive out of the way (you can do this without disconnecting anything). | ||
+ | |||
+ | {{drive-and-header.jpg|Drive and header board}} | ||
+ | |||
+ | Gently lever the header board up until disconnected. You will then be able to remove the drive + header board assembly. Ease the header board off the drive. Unscrew the drive from its casing, and replace it with the new drive. | ||
+ | |||
+ | ===== Reassembly ===== | ||
+ | |||
+ | Reassembly is, as you might expect, the reverse of removal. | ||
+ | |||
+ | Ease ribbon cables carefully back into their connectors. After replacing the top cover, press it firmly at the back by the screen; there should be a few clicks as it pops back into place. | ||
+ | |||
+ | |||
+ | ===== Thanks ===== | ||
+ | |||
+ | Thanks to StefanVGN-A197XP for the original instructions. | ||
+ |